- All Items
- Clamp Meter
- Digital Insulation Tester
- Digital Multimeter
- Digital Panel Meter
- Frequency Meter
- I/O's & Converters
- Insulation Tester
- Lux Meter
- Medical Products
- Multi function Meters
- Network Analyzers
- Power Analyzer
- Power Supply
- Protector Relays
- Special Instruments
- Test Kit
- Thickness Gauge
Tools & Instruments
Features and Benefits Electric Isolation between input, output and power supply, prevents falsified measurement due to spurious potentials. The flexibility provided by more than 250...
Description The transducer RISH CON - CA/CV converts a sinusoidal AC Current or AC Voltage into a load independent DC Current or a load independent DC Voltage...
Overview The transducer RISH CON - CA/CV converts a sinusoidal or distorted AC Current or AC Voltage into a load independent DC Current or a load independent...
Features For all heavy-current power system variables Up to 6 outputs (2A + 4D or 4A + 2D or 2A or 3A) Input voltage up...
Overview The Rish CON - Hz transducer is used for frequency measurement. The output signal is proportional to measured frequency and is either load independent DC Current...
Overview The RISH CON - V / RISH CON - I is used to measure and convert AC Voltage or Current input into an proportional DC current...
Features Continuous conversion of high current or high voltage signals. Standard d.c. current or d.c. voltage output signal. Small dimensions. 0.2 accuracy class. Fully programmable...
Product Description Thin-walled casing - 6.2 mm. Standardized d.c. current output signal 4-20 mA. Supply from a current loop. Datasheet
Features Input variable (temperature, a variation of resistance, DC signal) and measuring range programmed using PC / Simplifies project planning and engineering (the final measuring...
Features Simultaneous measurement of several variables of a heavy current power system / full supervision of an asymmetrically loaded four-wire power system, rated current 1...
Features True RMS measurement Fully onsite programmable input PT & CT ratio Detection and signalling of incorrect phase sequence THD Measurement Programmable parameters through the...
Product Description Built-in temperature and humidity sensor. Calculation of selected physical quantities (dew-point temperature, absolute humidity) – (only P18). 2 analog outputs 0/4…20 mA or...
Features / Benefits Transfer of data via a LON interface with an FTT-10A transceiver and LONTALK® protocol Simultaneous measurement of several variables of a heavy current...
Features Arithmetical mean value measurement Calibration to RMS with sine waveform (Average Value) Accuracy class 0.2 as per International Standard IEC/EN 60 688 Wide range...
Features / Benefits Input tap resistance and measuring range programmed using PC / Simplifies project planning and engineering (the final measuring range can be determined...
Features / Benefits Input measuring range can be programmed using PC / Simplifies project planning and engineering (the final range can be determined during commissioning)....
Overview The Rish CON - P transducer is used to measure and convert active, reactive, apparent power, Phase angle & Power Factor of a Single-phase or Three-phase AC system...